![]() ![]() ![]() Can I register my Genie product online Yes. You can also refer to your owner’s manual for further instructions. and disconnect it from the Opener by pulling the Emergency Release Cord. Battery backups are also available for certain model Genie garage door openers, these allow you to continue to use the garage door opener during a power outage. To keep the Door from moving, close the Door. 3 During programming, the Door Opener could begin to run, so stay away from. 2 Do Not allow children to play with Wireless Keypad. Programming Accessories Genie Garage Door Openers (For Intellicode products only). Test by entering the PIN and pressing the UP/DOWN arrow key once. 1 Keep people clear of opening while Door is moving. Model 1: Intellicode Model GWKIC, ACSDG printed on the cover).While the purple light is blinking (30 seconds), go to the keypad, enter the new code you programmed into the keypad, and slowly press and release the UP/DOWN arrow key several times until the door activates.Upon releasing the square button, the blue light will turn off and the long purple button will start to blink.Press and hold the square PROGRAM button (shown in the diagram above) located on the bottom of the motor head, until the round LED turns blue and release the button.Enter your PIN ( from three to eight characters).Test by entering your PIN and pressing the UP/DOWN arrow key once.Wait 30 seconds until the LED turns off.On the wireless keypad, enter your PIN and press the UP/DOWN arrow key 3, 4, or 5 times until the door activates.If your keypad looks like this, use these instructions: Resetting your Keypad. Use an existing remote to unlock the system by pressing it once only. Wireless Keypad Programming Instructions.Lighted Wall Button (some models) Operates door operator from inside garage. INTELLICODE® Multi-Button Remote Control Operates multiple Intellicode® equipped door operators. Press the square PROGRAM button and release again. INTELLICODE® 1-Button Remote Control Controls door operator by allowing the garage door to be opened and closed remotely.(Note: If the round, blue LED turns off and the long, purple light starts blinking, go to the instructions for Intellicode 2 below.) Press and hold the square PROGRAM button located on the bottom of the motor unit, until both the round and cylindrical LEDs turn blue.If your door opener does not have an antenna, you have an external receiver, and you'll need to remove the external receiver cover to find the LEARN CODE button and the indicator LED. It is usually behind the light bulb cover, close to the antenna wire. Find the LEARN CODE button and the LED indicator light on your Genie motor unit inside the garage. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |